![]() Refer to detailed installation instructions packed with products. STEP 11 : Stacked Unit is now ready to be installed. DO NOT REVERSE THE ORDER OF STEPS 9 & 10.STEP 10 : Tighten screws on the washer side of the rear bracket. WARNING : Additional gas hook-up components are required for gas dryer. STEP 9 : Tighten screws on the dryer side of the rear bracket. Extra screws may be included with this kit. STEP 8 : LOOSELY assemble rear brackets to the back of the dryer using two (2) Screws- Phillips Pan Head (6006-001174) for each rear bracket as shown above. STEP 7 : Align rear brackets with mounting holes on the rear of dryer as shown above. (Stacking kit: SKK-7*, SKK-8*, for 27” models). When stacking your washer and dryer, your dryer should always be placed on top of your washer. Make sure the dryer’s leveling legs are tightened up.STEP 6 : Lift and position dryer into the position on the washer shown above, slide dryer backwards to make contact with rear bracketsĬAUTION : To prevent noise, check the followings. * Case A only : Before installing the rear bracket, loosen two screws (Screw-Hex) on the Cover Top that is secured to the frame. That isn’t an issue for typical loads, but it could force you to break up larger loads, like blankets and bedding. Make sure the washer and dryer can be stacked and fit together with the same stacking kit. Compatible appliances: You can’t just choose machines at random. Make sure to get a kit compatible with the size and brand of your washer and dryer. Downsides to Stacking a Washer and Dryer Depending on the machines, you may give up some capacity in both the washer and dryer. A stacking kit gives you brackets and clips sized for your specific machines that will keep them in place. STEP 5-3 : Loosely assemble the Rear Bracket (DC61-03846A) to the washer as shown above in either case A or Case B, Use (2) Screws-Hex Head (6009-001476) with washers (DC60-00044A) to the each hole of Cover Top and Frame. Make sure the washer and dryer can be stacked and fit together with the same stacking kit. Washer (Stacking kit: SKK-BB, for 30” models) * Before installing the rear bracket, loosen two screws (Screw-Hex) on the Cover Top that is secured to the frame. Use two (2) Screws-Hex Head (6002-001431) with washers (DC60-00044A) in each washing machine Top Cover tail, per bracket. STEP 5-2 : LOOSELY assemble the Rear Brackets (DC61-04955A) to the washer as shown below. Strength, durability and performance are at the center of the newly refined Crossover 2.0 by Wascomat small chassis front load stacked washer & dryer combo. STEP 5-1 : LOOSELY assemble the Rear Brackets (DC61-04160A) to the washer as shown below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |